Introduction

Summary

Availability

This unit is currently unavailable.

Note

Please check that your computer meets the minimum System Requirements if you are attending via Distance/Off-Campus.

Units are offered in attending mode unless otherwise indicated (that is attendance is required at the campus identified). A unit identified as offered by distance, that is there is no requirement for attendance, is identified with a nominal enrolment campus. A unit offered to both attending students and by distance from the same campus is identified as having both modes of study.

Special approval is required for enrolment into TNE Program units.

TNE Program units special approval requirements.

* The Final WW Date is the final date from which you can withdraw from the unit without academic penalty, however you will still incur a financial liability (see withdrawal dates explained for more information).

Unit census dates currently displaying for 2020 are indicative and subject to change. Finalised census dates for 2020 will be available from the 1st October 2020.

About Census Dates

Learning Outcomes

1. Design concrete beams, columns and slabs with suitable member dimensions and steel reinforcement.

2. Evaluate the properties of fresh and hardened concrete using theoretical and experimental methods.

3. Develop documentation for concrete structures that conform to the requirements of AS3600 the Australian Standard for Concrete Structures.

Fees

Domestic

Fees for next year will be published in October. The fees above only apply for the year shown.

Please note: international students should refer to this page to get an indicative course cost.

Requisites

Prerequisites

ENG222

Mutual Exclusions

You cannot enrol in this unit as well as the following:

KNE457

Teaching

Textbooks

The University reserves the right to amend or remove courses and unit availabilities, as appropriate.