Courses & Units

Fundamentals of Marine Fabrication JVE140

Launceston

Note:

Delivered under agreement with Alanvale TASTafe

Introduction

This unit provides the students with the knowledge and skills to plan, manage, and carry out fundamental work in preparation for various marine fabrication, repair and maintenance. It enables the student to use various hand and power tools for the purposes mentioned above. Further the student acquires the skills to use various measuring tools.

This unit meet the requirements for knowledge, understanding and proficiency set out by the Maritime Training Package MAR, the STCW 2010 (Manila Amendments) and Table A-III/1 and AIII/2 of the STCW code.

Summary

Unit name Fundamentals of Marine Fabrication
Unit code JVE140
Credit points 6.25
Faculty/School College of Sciences and Engineering
Australian Maritime College
Discipline Seafaring
Coordinator

Abdullah Sardar

Teaching staff

External Delivery – Alanvale TASTafe teaching team

Level Introductory
Available as student elective? No
Breadth Unit? No

Availability

Location Study period Attendance options Available to
Launceston AMC MT Main Block 1 On-Campus International Domestic
Launceston AMC MT Main Block 3 On-Campus International Domestic
Launceston AMC MT Post Block 4 On-Campus International Domestic

Key

On-campus
Off-Campus
International students
Domestic students
Note

Please check that your computer meets the minimum System Requirements if you are attending via Distance/Off-Campus.

Units are offered in attending mode unless otherwise indicated (that is attendance is required at the campus identified). A unit identified as offered by distance, that is there is no requirement for attendance, is identified with a nominal enrolment campus. A unit offered to both attending students and by distance from the same campus is identified as having both modes of study.

Special approval is required for enrolment into TNE Program units.

TNE Program units special approval requirements.

Key Dates

Study Period Start date Census date WW date End date
AMC MT Main Block 1 1/2/2021 10/6/2021 18/6/2021 13/6/2021
AMC MT Main Block 3 14/6/2021 11/11/2021 12/11/2021 14/11/2021
AMC MT Post Block 4 15/11/2021 22/12/2021 25/12/2021 26/12/2021

* The Final WW Date is the final date from which you can withdraw from the unit without academic penalty, however you will still incur a financial liability (see withdrawal dates explained for more information).

About Census Dates

Fees

Domestic

Field of Education Commencing Student Contribution 1 Grandfathered Student Contribution 1 Approved Pathway Student Contribution 2 Domestic Full Fee
031705 $496.0 $496.0 not applicable $1,413.0

1 Please refer here more information on student contribution amounts.
2 The information on Approved Pathway courses can be found here.
If you have any questions in relation to the fees, please contact UConnect or more information is available on StudyAssist.

Please note: international students should refer to this page to get an indicative course cost.

Requisites

Mutual Exclusions

You cannot enrol in this unit as well as the following:

JVE132

Teaching

Teaching Pattern

Practical

Assessment

Practical Assessment

MEM18001C - Perform general machining
MEM18002B - Use power tools/hand held operations
MEM18002B - Perform engineering measurements
TimetableView the lecture timetable | View the full unit timetable

Textbooks

RequiredNone
Booktopia textbook links

The University reserves the right to amend or remove courses and unit availabilities, as appropriate.