Courses & Units

Marine Electrical Powering & Systems JEE362

Launceston

Introduction

The purpose of this unit is to develop engineering ability for system level design and commissioning of electrical powering and systems within marine and offshore sectors. The unit focuses on estimation of plant power electrical loads, design and analysis of marine electrical machines, power electronics and powering systems.

Summary

Unit name Marine Electrical Powering & Systems
Unit code JEE362
Credit points 12.5
Faculty/School College of Sciences and Engineering
Australian Maritime College
Discipline National Centre for Maritime Engineering and Hydrodynamics
Coordinator

Dr Hung Nguyen

Teaching staff

Mr Monaaf Al-Falahi

Level Advanced
Available as student elective? Yes
Breadth Unit? No

Availability

Location Study period Attendance options Available to
Launceston Semester 2 On-Campus International Domestic

Key

On-campus
Off-Campus
International students
Domestic students
Note

Please check that your computer meets the minimum System Requirements if you are attending via Distance/Off-Campus.

Units are offered in attending mode unless otherwise indicated (that is attendance is required at the campus identified). A unit identified as offered by distance, that is there is no requirement for attendance, is identified with a nominal enrolment campus. A unit offered to both attending students and by distance from the same campus is identified as having both modes of study.

Special approval is required for enrolment into TNE Program units.

TNE Program units special approval requirements.

Key Dates

Study Period Start date Census date WW date End date
Semester 2 15/7/2019 9/8/2019 2/9/2019 20/10/2019

* The Final WW Date is the final date from which you can withdraw from the unit without academic penalty, however you will still incur a financial liability (see withdrawal dates explained for more information).

Unit census dates currently displaying for 2019 are indicative and subject to change. Finalised census dates for 2019 will be available from the 1st October 2018.

About Census Dates

Learning Outcomes

ILO 1 Estimate plant electrical loads and the required power supply capacity using single-line diagrams, schematic drawings of electrical wiring, distribution and protection systems.

ILO 2 Explain operating principles of electric machines and solid-state semiconductors used in power electronics and marine and offshore industries.

ILO 3 Perform basic calculations and analysis of DC, AC power systems and power electronic systems.

ILO 4 Design marine electrical powering and systems in compliance with statutory and classification society regulations and rules.

ILO 5 Perform analysis and inspection of marine electrical machines and powering systems.

Fees

Domestic

Band CSP Student Contribution Full Fee Paying (domestic) Field of Education
2 2019: $1,169.00 2019: $2,731.00 031701

Fees for next year will be published in October. The fees above only apply for the year shown.

Please note: international students should refer to this page to get an indicative course cost.

Requisites

Prerequisites

JEE344

Teaching

Teaching Pattern

1 x 3-hr lecture and 1 x 1-hr tutorial weekly (13 weeks)

Assessment

Design Assignments 65%, Lab 25%, Tutorials 10%

TimetableView the lecture timetable | View the full unit timetable

Textbooks

RequiredNone
Co-op Bookshop links

The University reserves the right to amend or remove courses and unit availabilities, as appropriate.