Launceston
Delivered under agreement with Alanvale TASTafe
Introduction
This unit provides the students with the knowledge and skills to plan, manage, and carry out fundamental work in preparation for various marine fabrication, repair and maintenance. It enables the student to use various hand and power tools for the purposes mentioned above. Further the student acquires the skills to use various measuring tools.
This unit meet the requirements for knowledge, understanding and proficiency set out by the Maritime Training Package MAR, the STCW 2010 (Manila Amendments) and Table A-III/1 and AIII/2 of the STCW code.
Summary 2020
| Unit name | Fundamentals of Marine Fabrication |
|---|---|
| Unit code | JVE140 |
| Credit points | 6.25 |
| Faculty/School | College of Sciences and Engineering Australian Maritime College |
| Discipline | Seafaring |
| Coordinator | Abdullah Sardar |
| Teaching staff | External Delivery – Alanvale TASTafe teaching team |
| Level | Introductory |
| Available as student elective? | No |
| Breadth Unit? | No |
Availability
Note
Please check that your computer meets the minimum System Requirements if you are attending via Distance/Off-Campus.
Units are offered in attending mode unless otherwise indicated (that is attendance is required at the campus identified). A unit identified as offered by distance, that is there is no requirement for attendance, is identified with a nominal enrolment campus. A unit offered to both attending students and by distance from the same campus is identified as having both modes of study.
Special approval is required for enrolment into TNE Program units.
TNE Program units special approval requirements.
* The Final WW Date is the final date from which you can withdraw from the unit without academic penalty, however you will still incur a financial liability (see withdrawal dates explained for more information).
Fees
Requisites
Mutual Exclusions
You cannot enrol in this unit as well as the following:
JVE132
Teaching
| Teaching Pattern | Practical |
|---|---|
| Assessment | Practical Assessment MEM18001C - Perform general machining MEM18002B - Use power tools/hand held operations MEM18002B - Perform engineering measurements |
| Timetable | View the lecture timetable | View the full unit timetable |
Textbooks
| Required | None |
|---|
The University reserves the right to amend or remove courses and unit availabilities, as appropriate.