Engineering Materials unit (JEE137)

Launceston

Introduction

This unit introduces students to the use of materials in an engineering context. Students will learn the properties used to classify materials from an engineering perspective, and how these are determined. Students will apply this knowledge to characterise materials using experimental testing and then compare this to supplier data. Using these results, students will identify treatments and processes that alter material properties to meet design requirements. This unit is a foundation unit for all engineering disciplines and the knowledge gained will be applied throughout the degree.

Summary

Unit name	Engineering Materials
Unit code	JEE137
Credit points	12.5
College/School	Sciences and Engineering Australian Maritime College
Discipline	National Centre for Maritime Engineering and Hydrodynamics
Coordinator	Doctor Tom Mitchell Ferguson
Available as an elective?	Yes
Delivered By	University of Tasmania
Level	Introductory

Availability

Location	Study period	Attendance options		Available to
Launceston	Semester 2

Note

Please check that your computer meets the minimum System Requirements if you are attending via Distance/Off-Campus.

Units are offered in attending mode unless otherwise indicated (that is attendance is required at the campus identified). A unit identified as offered by distance, that is there is no requirement for attendance, is identified with a nominal enrolment campus. A unit offered to both attending students and by distance from the same campus is identified as having both modes of study.

Key Dates

Study Period	Start date	Census date	WW date	End date
Semester 2	5/7/2026	27/7/2026	30/8/2026	24/10/2026

* The Final WW Date is the final date from which you can withdraw from the unit without academic penalty, however you will still incur a financial liability (refer to How do I withdraw from a unit? for more information).

Unit census dates currently displaying for 2026 are indicative and subject to change. Finalised census dates for 2026 will be available from the 1st October 2025. Note census date cutoff is 11.59pm AEST (AEDT during October to March).

About Census Dates

Learning Outcomes

• Explain key engineering material properties and their importance in engineering applications.
• Apply appropriate testing procedures to determine the properties of common engineering materials.
• Compare supplier data with measured material properties to confirm material suitability for a given engineering application.
• Explain processes that alter the performance and durability of common engineering materials.

Fee Information

Field of Education	Commencing Student Contribution 1,3	Grandfathered Student Contribution 1,3	Approved Pathway Course Student Contribution 2,3	Domestic Full Fee 4
030305	$1,192.00	$1,192.00	not applicable	$3,401.00

• Available as a Commonwealth Supported Place
• HECS-HELP is available on this unit, depending on your eligibility³
• FEE-HELP is available on this unit, depending on your eligibility⁴

¹ Please refer to more information on student contribution amounts.
² Please refer to more information on eligibility and Approved Pathway courses.
³ Please refer to more information on eligibility for HECS-HELP.
⁴ Please refer to more information on eligibility for FEE-HELP.

If you have any questions in relation to the fees, please contact UniConnect or more information is available on StudyAssist.

Please note: international students should refer to What is an indicative Fee? to get an indicative course cost.

Requisites

Mutual Exclusions

You cannot enrol in this unit as well as the following:

JEE125|KAA113

Teaching

Assessment	Material Property Analysis Project (20%)|Class Test 2 (25%)|Class Tests (25%)|Laboratory Reports (30%)
Timetable	View the lecture timetable | View the full unit timetable

Textbooks

Required	Required readings will be listed in the unit outline prior to the start of classes.

The University reserves the right to amend or remove courses and unit availabilities, as appropriate.